Charge controller Victron SmartSolar MPPT 100/20 Bluetooth

159.00
  • New
More than 10 pieces in stock.
Delivered within 24 hours.
The Victron SmartSolar MPPT 100/20 is the charge controller for anyone who wants the maximum from their solar setup. MPPT technology for shorter charging times, Bluetooth built in, compatible with lead-acid, AGM, GEL and lithium. Up to 20 A charge current, up to 100 V panel voltage, for 12 V and 24 V systems. SmartSolar by Victron. read more
Add to wishlist
Compare
Compare Products

 

Swiss online shop

 

Encrypted payment

 

Shipping within 48 hours

Between your solar panel and your battery sits the component that decides charging time, yield and lifespan: the charge controller. Save here, and you waste sunlight. The Victron SmartSolar MPPT 100/20 is built for everyone who refuses to do exactly that — in the camper, on the boat, at the garden shed or in an off-grid setup. And with 20 A and up to 100 V panel voltage, it's the right choice as soon as the system grows a little.

MPPT. The top class of charge controllers. Maximum Power Point Tracking is the premier league of solar charging. A microprocessor determines the optimal operating point of your module several times per second and converts surplus voltage into additional charge current. The result isn't a marketing promise but physics: shorter charging times and the best possible yield from every hour of sun. Where simple PWM controllers leave yield on the table, the MPPT brings it into the battery.

Bluetooth is already built in. No extra module, no cable. The SmartSolar communicates out of the box. With the free VictronConnect app you read yield, state of charge and history straight on your phone — and set the controller to your battery in a few taps. Full control, no tools, no cable clutter.

For every battery you run. Lead-acid, AGM, GEL or lithium — the SmartSolar 100/20 charges them all with the right profile. You pick your battery type in the app, and the controller applies the matching charge program. That way you get maximum capacity while protecting your battery's lifespan.

More headroom for bigger systems. On a 12 V battery you run at least one 12 V panel, ideally two 12 V panels in series or one 24 V panel, at most three 12 V panels in series. With up to 100 V solar open-circuit voltage and 20 A charge current, you have noticeably more headroom than on the 75/15. Important: mind the open-circuit voltage of your panels — it must never exceed 100 V.

Camper and motorhome. More yield on every drive, a full battery by evening — and the app showing what the roof is producing in real time.

Boat and off-grid. Rugged charging with reserve. When the panel area grows, the 100/20 keeps up — and squeezes the maximum from every amp-hour.

SmartSolar. By Victron. At ****AutoSolar****. For decades Victron has stood for charging technology that doesn't fade under hard, continuous use. We supply it as your Swiss specialist retailer, with advice that fits your setup. Quality you notice at the battery.

Produkt-Nummer

mppt100_20smart

    Was ist der Unterschied von einem PWM-Laderegler und einem MPPT Laderegler?

    Der einfacher PWM Laderegler kann die Spannung des Solarmoduls regeln. Beim MPPT-Laderegler ist der Vorteil, dass dieser der Kennlinie des Solarmoduls besser folgen kann. Zusätzlich kann der MPPT-Laderegler  Spannung und Strom regulieren. Diese Vorteile führen zu einem Leistungsgewinn von bis zu 30%. 


No reviews available for this product yet.